In Ontario, the attainment of nitrification (oxidation of ammonia) in activated sludge plants is receiving increased attention. Nitrification of waste water is a necessary requirement because it reduces plant discharge of nitrogenous oxygen demand and/or toxic ammonia. However, this new requirement will result in added responsibility for…

This military-developed text contains the first section of a four-part course to train environmental support specialists. Covered in the individual course blocks are basic mathematics necessary to the study of waste processing and water analysis as well as waste and waste processing and water and water analysis (basic chemistry, air forced water…

This module discusses some of the objectives of incorporating vegetative cover in land treatment systems. Specific crops and forest cover are mentioned in relation to benefits associated with each, and specific treatment alternatives (irrigation, overland flow, and rapid infiltration) are included in relation to vegetative cover considerations.…

This military-developed text contains the final section of a four-part course to train environmental support specialists. Covered in the individual course blocks are maintenance of water and waste processing system components (external corrosion control, cathodic protection, drive equipment, pipelines and valves, meters and recorders, chemical…

This module examines the basic properties of soil which have an influence on the success of land treatment of wastes. These relevant properties include soil texture, soil structure, permeability, infiltration, available water capacity, and cation exchange capacity. Biological, chemical and physical mechanisms work to remove and renovate wastes…

This module describes important criteria to use in evaluating land for waste treatment sites and tells where the necessary information for such evaluation can be obtained. Among the important criteria for evaluation are climate, land use of potential site and surrounding areas, topography, drainage characteristics, soil properties, and geology.…

The purpose of this module is to develop a general procedure to decide the feasibility of land application as a waste management alternative, given a specific problem situation. This information provides a framework within which to apply the information presented in all other modules in the program. An outline of the general procedure followed in…

This module introduces the physical, biological, and chemical constituents of wastewaters and sludges which are of concern in land treatment systems. The characteristics of typical municipal wastewater are tabulated for strong, medium, and weak sewages. Some of the factors affecting pollutant concentrations are listed. Flow, distribution and…

This military-developed text contains the third section of a four-part course to train environmental support specialists. Covered in the individual sections are field sanitation, classes and sources of waste, composition and characteristics of sewage, principles of sewage treatment, primary waste treatment, secondary waste treatment, tertiary…

A study examined the impact of the Centers for Disease Control's home study course in community hygiene on the job performance of 45 sanitarians in 30 districts throughout North Carolina. Data were collected from: (1) pre- and post-tests that evaluated the sanitarians' mastery of knowledge in such areas as water supply, sewage disposal, solid…

This module describes the following conventional treatment systems and evaluates their use as pretreatment steps for land application: preliminary, primary, secondary, disinfection, and advanced waste treatment. Effluent qualities are summarized, a brief discussion of application systems is given, and cost comparisons are discussed in some detail.…

This document is an instructional module prepared in objective form for use by an instructor familiar with mathematics as applied to water and wastewater treatment plant operation. Included are objectives, instructor guides and student handouts. This is the third level of a three module series and is concerned with statistics, total head, steady…

This guide, which includes an outline of 222 hours of technical training integrated with training in community organization techniques, is intended for trainers who prepare Peace Corps water and sanitation technicians and engineers for field service. The training program developed by the guide covers these subject areas: community development,…

This student module on industrial sanitation and personal facilities is one of 50 modules concerned with job safety and health. This module deals wth many facets of industrial sanitation and the facilities industries should provide so that proper health procedures may be followed. Following the introduction, 14 objectives (each keyed to a page in…

Programs for calculating gravity flow using a Texas Instruments SR-52 and the Programmed Manning Equation are given and discussed. (MR)