ERIC Number: ED339884
Record Type: Non-Journal
Publication Date: 1990
Reference Count: N/A
Stamping Die Making. 439-318/320.
Yunke, P.; And Others
Each unit in this curriculum guide on stamping die making contains an introduction, objectives, materials required, lessons, space for notes, figures, and diagrams. There are 29 units in this guide, dealing with the following topics: EZ-MILL programming; EZ-MILL BATT; print of punch and EZ-MILL part programming; download to Computer Numerical Control Bridgeport Mill; set tool length offsets; edge finding; test run; run program; pocket milling; translation, y-symmetry, rotation, scaling; EZ-Electrical Discharge Machining (EDM) programming; EZ-EDM BATT programming; wire EDM; wire-cut EDM; spark information and cutting charts; squaring the wire; set up and start point location; the main menu; principles of wire-cut EDM; Mitsubishi Medi-Apt programming; CRT settings and display unit configuration of Mitsubishi wire EDM; setup and the wire EDM; Media-Apt computer program development; program methods of describing lines off of circles and points; manual programming of piecepart; setting up and using wire EDM tools and fixtures; wire EDM setting up and taper angle cutting; sample progressive die; and Medi-Apt computer commands. Twenty-one appendixes give further information, help, and answer keys. (NLA)
Publication Type: Guides - Classroom - Learner; Guides - Classroom - Teacher
Education Level: N/A
Audience: Students; Teachers; Practitioners
Sponsor: Wisconsin State Board of Vocational, Technical, and Adult Education, Madison.
Authoring Institution: Milwaukee Area Technical Coll., WI.