THIS GUIDE IS FOR INDIVIDUAL STUDENT USE IN STUDYING DIRECT CURRENT MAGNETIC MOTOR CONTROL IN ELECTRICAL-ELECTRONIC PROGRAMS. IT WAS DEVELOPED BY AN INSTRUCTIONAL MATERIALS SPECIALIST AND ADVISERS. EACH OF THE 15 ASSIGNMENT SHEETS PROVIDES THE LESSON SUBJECT, PURPOSE, INTRODUCTORY INFORMATION, STUDY REFERENCES, AND PROBLEMS. SOME OF THE LESSONS ARE (1) DIRECT-CURRENT CONTACTORS, (2) D-C BRAKES AND SOLENOIDS, (3) CHARACTERISTICS AND ACCELERATION OF SHUNT MOTORS, (4) HOIST CONTROLLERS FOR SERIES MOTORS, (5) ROTATING AMPLIFIER CONTROL, AND (6) DIRECT-CURRENT CONTROL CIRCUIT APPLICATIONS. THE LESSONS ARE KEYED TO TWO REQUIRED TEXTBOOKS, AND FIVE BOOKS TO PROVIDE SUPPLEMENTARY INFORMATION ARE LISTED. THE MATERIAL IS TO BE USED BY THE INDIVIDUAL STUDENT UNDER TEACHER DIRECTION FOR 40 CLASSROOM HOURS. THE TEACHER SHOULD HAVE THE NORMAL EDUCATION REQUIRED OF ELECTRICAL-ELECTRONIC INSTRUCTORS, AND THE STUDENTS WILL USUALLY BE EMPLOYED IN THE ELECTRICAL-ELECTRONIC INDUSTRIES. THE INSTRUCTOR'S GUIDE (VT 000 321) PROVIDES STEP-BY-STEP SOLUTIONS TO THE ASSIGNMENT SHEET AND TEST PROBLEMS. THE UNIT IS PART OF A SERIES OF 30- TO 40-HOUR UNITS WHICH PROGRESS THROUGH BASIC MATHEMATICS, BASIC ELECTRICITY, CONVENTIONAL MOTOR CONTROLS, BASIC ELECTRONICS, ADVANCED ELECTRONICS, AND STATIC ELECTRONIC CONTROLS. ASSIGNMENTS AND INSTRUCTOR'S GUIDES FOR THE VARIOUS UNITS IN THE ELECTRICAL-ELECTRONIC PROGRAM ARE AVAILABLE AS VT 000 284-VT 000 287, VT 000 308-VT 000 321, AND VT 005 507. THIS DOCUMENT IS AVAILABLE FOR $3.00 FROM INDUSTRIAL EDUCATION DEPARTMENT, DIVISION OF EXTENSION, THE UNIVERSITY OF TEXAS, AUSTIN, TEXAS 78712. (HC)