This eighth in a series of ten modules for a course titled Welding Inspection describes controls necessary to place the proper electrode or rod at each welding station. More specifically, the module describes use of the American Welding Society specifications, control of weld filler material after receipt from the supplier, and methods of ensuring proper application of the filler material. The module follows a typical format that includes the following sections: (1) introduction, (2) module prerequisites, (3) objectives, (4) notes to instructor/student, (5) subject matter, (6) materials needed, (7) procedures, (8) data table, (9) reference materials, (10) test. (The course is one of fifteen technical courses for the second year of a two-year postsecondary curriculum in Nuclear Quality Assurance/Quality Control Technology.) (LRA)